The electronics has arrived!

• Motor: Topwerpro 2409-12T
• ESC: Towerpro 18A
• Battery: 2s1000mAh 25-35C Loong-Max to start with
• Prop: 8*4 slowfly GWS

Hatch cut.


Break away motor-mount.






Hinge for the hatch.


Rare earth magnet for holding the latch.


One is strong enough to lift the whole plane!


A servo in place.


The two other servos in place.


Pushrod for the tail rudder done.


I use ball-links from an old T-Rex kit to make my pushrods.


3mm carbon tube with ball-links


Futaba 2.4GHz FASST Receiver mounted.


Speed-controler in place.


“Training wheel wings” glued on.


I used some clear hard plastic to protect the bottom of the spons.


Out in the snow.

Testflight!

Initially the plan was just to test-drive it around on the ground because the wife had the car so I couldn’t get to a field.
I walked to the nearest place that I could find with some flat ground and plugged in the battery.

The Hydro handles well on the snow but after a while my fingers got a little to itchy...
I thought that I would take of for just a short bit and land it directly, a little jump with other words.

Well this is how it ended:

Can you spot it?




Nothing serious, a few minutes of love and glue and she will be in the air again.