Home Forums Everything about everything else Help can''t move tail servo

Tagged: ,

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #61032
    mabadajo
    Participant

    I can’t move the tail servo from dronin, servo has 5v from the pdb and the signal wire goes to motor 4 on the kakute f4 v2.
    I have ticked the test output box, the motors work.
    I’ve been following Davids video : https://www.youtube.com/watch?reload=9&v=uZQvEJu7vG4&t=74s
    just think I’ve missed something.

    #61036
    jihlein
    Participant

    Servo wire should go to the LED pad, which is motor 4 in dRonin. Motor 4 pad is for the LEDs. While confusing, this was done to allow independent protocol selection for motors and servos.

    #61037
    mabadajo
    Participant

    genius, thanks mate

Viewing 3 posts - 1 through 3 (of 3 total)
  • The forum ‘Everything about everything else’ is closed to new topics and replies.