Matek 405-STD – For Bi and Tricopters

[Kevin_Erik]

See if there are updates for it. Odds are if your not looked in a while you may be surprised.

[Fosch]

Hi,

I updated my XSR firmware and fully erase my Taranis, without success to get a full telemtry 🙁
I still have only A2 (Lipo voltage), nothing else from the board…

Is there a parameter to change somewhere ? like a baudrate ?

How to know if I’m using the lastest MATEK F405 STD firmware (fw_matek405.tlfw) ?
Where to find the latest firmwares please ?

EDIT :
OK !!! I’ve just fully erased the board and now that’s working with XSR receiver !
I just lost 3 evenings working on it 🙂
Now I’m going to try with the R-XSR receiver

Attachments:

1. 

   Firmware.jpg
   

2. 

   Sensors-1.jpg
   

[Fosch]

So, XSR telemetry is working fine now, but not chance with R-XSR…

I don’t know, maybe my R-XSR SmartPort is dead… I’ll try with another R-XSR this week-end.

[Kevin_Erik]

You should contact Frsky directly about your problem and detail what you have done thus far. Odds are that they’ll either provide guidance or replace your receiver.

[AtomicHemi]

@Fosch when you swap between the XSR and R-XSR are you swapping the pins around in the connector? XSR & R-XSR have different pinouts on their connector even though its the same plug, I’ve pulled my hair out a few times on the same issue

[Fosch]

Hi

Yes I paid attention to the connector wiring. Anyway, thanks.

Maybe my s.port is dead,I will try it later but at moment I have lost too much time on this issue, I’m going to go ahead with my special build and keep XSR receiver for it 😉

[Author]

Posts