Wire retention plates

[hsamuels]

The plates that retain the wires aren’t flat on my tricopter. Are they all like this, or do I have to make tiny adjustments to the wires to get them to sit flat?

Attachments:

1. 

   plate.jpg
   

[Terje]

You need to realign the wires to make the plate sit flat against the body plate. Looks like the end of the wire is not quite sitting in the groove?

[Robert C]

I made the grooves a little bit bigger, as I had the same problem. You can use a knife to scrape some of the material away.

[hsamuels]

Thanks! I’ll take that as an opportunity to re-route the wires so it can fold more easily too.

[hsamuels]

Thanks! I’ll take that as an opportunity to re-route the wires so it can fold more easily too.

BTW, the little piece of white tape is so I can easily check that the tail boom hasn’t slipped out.

[Author]

Posts