Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 10 September, 2018 at 09:52 in reply to: Impossible Tail Duct (With .STL) #59233
    aaron.neill
    Participant

    Kevin

    Thanks for the reply. I would greatly appreciate if you could send me the files as I should be able to print this on my own printer. I totally agree with printing these in nylon. Wish me luck!

    10 September, 2018 at 00:35 in reply to: Impossible Tail Duct (With .STL) #59226
    aaron.neill
    Participant

    Has anyone tried these ducts on a Bicopter yet?? If not i will print these and test them on the bicopter frame.

    10 September, 2018 at 00:15 in reply to: Where in the world is your RCExplorer Copter? Link to map #59225
    aaron.neill
    Participant

    Co Antrim, Northern Ireland

    9 September, 2018 at 23:59 in reply to: BiCopter questions and concerns #59224
    aaron.neill
    Participant

    FPV is certainty achievable via a Tilt servo added to the camera. I have done this on fixed wing aircraft in the past.A personal preference of mine was to add a coloured plastic tube ( 2mm thick ) on the nose centred to the camera view so i knew if the aircraft was climbing or descending. I think the same principle could work for the Bicopter using the existing flight controller outputs.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)