Forum Replies Created
-
AuthorPosts
-
TerjeModerator
Looks good @jihlein!
Would you mind sharing the file for the rear part of the mount, that is made specific for the babytri?
TerjeModeratorHi Kevin, I’m going to ask you a few simple questions that will help me better understand the problems you are having. I hope you take no offence.
1) Have you installed Fusion360?
2) Have you imported the .F3D file(s)?
3) How old are you?
4) What country do you reside in?
5) What is your level of education?Cheers
TerjeModeratorIt is actually the servo that is the limiting factor. You might have to trim the mount plates on the servo to get enough clearance. Regarding servo mount, the original RCE mount should fit just fine. Alternatively cut down the tall mount to fit. I have not tested it against the new steel servo gears. Otherwise it is a trade off whether you want the mount or the servo to fail.
TerjeModeratorThe relative elasticity of ABS/ASA makes it a good candidate. Scale 101% or what ever shrinkage you experience. PETG works too, but in any case you should print spare motor mounts, since they tend to break on hard impact (not a perfect solution)
TerjeModeratorI made the low profile version for the Emax MT2208II (lovely motors btw), the 2207 you link to, are 3mm lower. To be honest, I don’t know.
TerjeModeratorWhen using the impossible tilt, the tail tune is unable to succeed because the acc is unable to pick up the movement of the motor… So pretty close to perfect 🙂
TerjeModeratorThat issue is more than outweigh by the mass of the motor not shifting as much side to side. The tail mechanism is mounted higher, yes, but the actual motor is at the same height or even lower, depending on which motor is used.
TerjeModeratorHave you tried the impossible tilt?
TerjeModeratorYou are maybe confusing STL and STP files? 🙂
TerjeModeratorI routinely use and alter somebody elses stp files from eg. GrabCad without issues.
TerjeModeratorYou should be able to import the stp file into Fusion360 and edit it.
I’ve just added the f3d file for you. If you don’t have Fusion360, get it. It’s free for personal use:
TerjeModerator@Kevin_Erik the stp file is included here: https://www.thingiverse.com/thing:1123176/#files ?
TerjeModeratorHi @Kevin_Erik
I’ve actually never used the original canopy, so I can’t say how to improve it. If you are referring to the the 3D printed version, I’ve moved away from that also. The 40mm spacer should prevent Lipo through camera incidents though.
I found that a 2mm plywood and 3D printed parts worked best for me – didn’t bother to upload the design though, since surprisingly few people know how to operate a gigsaw…
TerjeModeratorAny chance the github page will be updated with the current release of triflight? Maybe with a meaningful version numbering and changelog? 🙂
TerjeModeratorGive the BLHeli configurator plugin for Chrome a try 🙂
-
AuthorPosts