Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • in reply to: dRonin for Tricopters! (TriRonin) #63836
    jhendrix
    Participant

    I reflashed the firmware and setup a new model on my radio (my previous setup combined lots of operations onto 1 channel, now I split them up).
    All the tuning stuff now seems to work correctly. I can bench tail tune (servoCal) with it disarmed, it will also now arm and I can do the autotune and in air tail tune.
    Issue I have now is the copter seems to be unstable when adding lots of throttle.
    The only thing I can think of now is my servo speed is less than 120 degrees/sec, David’s was 244.

    in reply to: dRonin for Tricopters! (TriRonin) #63826
    jhendrix
    Participant

    I figure out the bench tail tune. The option has been renamed to ServoCal and you must arm the copter in order to do the tune.
    The problem I’m having now, is I can’t get the tricopter to arm. When I plug in the battery, I see the words fail in the upper right of the screen, I have no idea what it means and if this is the problem.
    Moving the rudder stick will move the tail, but I can’t get the motors to start. If I go into dronin, I can turn on the test outputs and the motors will spin (so I know everything is hooked up correctly).
    Any ideas what I can check to fix this problem?

    in reply to: dRonin for Tricopters! (TriRonin) #63825
    jhendrix
    Participant

    I’ve installed the 20190113 version of dRonin, and I’ve followed every step exactly.
    When I go to the flight modes, at 9:04 in the video, I do not have the option to select tail tune.
    How do I continue?

Viewing 3 posts - 1 through 3 (of 3 total)