[jj_uk]

Would it be possible to merge the changes that triflight offers back into the iNav code so that iNav would then support tricopters, and allow us to use all the boards and features of iNav?

In essence, removing the need to triflight for tricopters, and just using iNav instead.

[jj_uk]

Sweeeeet ! – The sooner the Betaflight F3 board is supported the better as i’d like to use the OSD and the TriFlight tail tune.

I’ll send him a donation, see if that will speed it up a bit 😉

[jj_uk]

I would like to ask if the Betaflight F3 FC will be supported any time soon? It has onboard current sensor, built in PDB and an OSD that id like to use!

[jj_uk]

Is there a support forum thread for triflight? I’d like to ask a few questions regarding setup…

[jj_uk]

Looking at the docs for triflight, except for the RCExplorer board, none of the other boards detail where the feedback wire should be connected.
Where should it be connected? Is it the same for all boards?

My guess would be:
motor 1,2,3 = motors
motor 4 = servo
motor 5 = feedback

I’m using the BFF3 board, it has only 4 motor pins, so that doesn’t look like its supported anyway 🙁

I’m a bit stuck here.

[Author]

Posts