Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • in reply to: BETAFLIGHT 4.0.3 and KAKUTF4V2 #64534
    Rinsley
    Participant

    Hi everyone,
    i switch to Betaflight last weekend for the first time and even if i’m a beginner for multicopters, i do what i want with your dump file, so thank you all.

    My config:
    -Betaflight version 4.1.1
    -Tri LR form David
    -the same for electronic parts
    -GPS M8 form TBS (Rx6 / Tx6 pads)
    -Crossfire setup for commands (Rx3 / Tx3 pads)
    -DJI air unit and googles system for FPV part(Rx4 / Tx4 pads)

    I just finish to wellding the OSD for DJI, the last week i flew for test the tri LR and it flew great.
    So i want to share my config with my dump from CLI.

    in reply to: DJI FPV system #64381
    Rinsley
    Participant

    Hi adamcooney1,

    i’m using it but, i’m also a beginner in FPV and multicopter’s world (the Tri LR is my first build =’] )

    So even i nether watched into an analog googles, i had a big feelings when i taken off for the first time. The only ones i saw were on youtube.
    I’m flying for the moment with the stock antennas and it’s really awesome.
    The good thing is that you just have to make 2 or 4 welding and it’s ready to fly.
    The negative thing is that is not an open software/hardware.

    Sorry if i did some mistakes of grammar i’m not american or englishman.

    Rinsley

Viewing 2 posts - 1 through 2 (of 2 total)