Forum Replies Created

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • in reply to: Tricopter Pins #24320
    Stephen
    Participant

    Printed it with the pin back, will see that it works.

    Attachments:
    in reply to: Tricopter Pins #24308
    Stephen
    Participant

    Here is the first go round. I’ll add the pin post and give it another shot, the top got a little out of round when I wasn’t so careful in removing the support.

    I think the only thing the will potentially need to modified in the original file would be to raise the plate part of the copter a little bit and add a little bit larger fillet radius.

    Another one with the post is printing as we speak.

    in reply to: Tricopter Pins #24305
    Stephen
    Participant

    I’m in the other side of the pond but the part I printed last night should be done once I head into work. I’ll put photos up. Also I can add the post and print again to test for the pin back and/or @Terje can to the original file.

    in reply to: Tricopter Pins #24272
    Stephen
    Participant

    I’ll try and get this setup and printing later today. See what it actually comes out like in the casting material. What type of pin back are we wanting? casting a moving joint will definitely add complexity and likely cost. So a simple post style might make the most sense.

    in reply to: Tricopter Pins #24230
    Stephen
    Participant

    I can print the mould making material from an micro-SLA printer. So detail would still be very accurate even at a slightly scaled down size. I was originally thinking about 30mm diameter. @Terje if you wouldn’t mind sending me the file I can run at test print at a scaled down size. Are you doing design in solidworks?

    in reply to: Tricopter Pins #24189
    Stephen
    Participant

    Here is another version I was also pondering. Not specific to the tricopter flyers, but anyone that enjoys the work that David has done and is continuing to do.

    This was just quick idea based off a logo I ripped from vimeo.

    in reply to: Tricopter Pins #24186
    Stephen
    Participant

    This looks awesome. Any chance we can make the text a little deeper but rounded. Almost as if it was milled with a tiny ball nose bit.

Viewing 7 posts - 1 through 7 (of 7 total)