[touchthebitum]

I tried your custom firmware and I was able to arm all 3 motors in Dshot 150 mode. I don’t understand the servo behaviour. I’m able to move it only to the right and not to the left. I can move the servo with the radio only when the copter is armed.
The copter compensate in the opposite way when I make a yaw movement by hand. I made the zero of the servo and when I arm, servo is in the middle.
Could you tell me where I’m wrong?
Thanks

[touchthebitum]

Ok, I’ll try that.
I think I don’t have to desolder anything since the Tricopter LR Triflight setup already uses this map.
Thanks

[touchthebitum]

Great! I’m waiting for my gps module and then I’ll try it.
So I don’t have to de-solder anything on my Kakute and try it ?
Thanks

[touchthebitum]

It’s ok , the OSD is ok but I can’t use the smart audio to setup my VTX Holybro Atlatl.
Any idea ?
Thanks

[touchthebitum]

Unfortunately I don’t have these skills.
It will be a pleasure if you build it for me.
Thank you very much

[touchthebitum]

Hello
I’m trying DRonin with triflight on my Kakute F4 V2. Someone knows if it is possible to have OSD like Betaflight? I don’t find it on DRonin menu.
Thanks

[touchthebitum]

Hello Damightyj
I’m interested in trying Arducopter on my Kakute F4 V2 but I was a bit confused about remapping procedure. I would have some questions about settings.
If I used LED strip as a third output for servo, could I use Dshot or I have to remain on pwm?
Thanks

[touchthebitum]

Hello !
I plan to use Arducopter on a Kakute F4 V2 too but I don’t think it will use servo feedback.
Maybe oscillations are due to this…
Did you have to remap ?

[touchthebitum]

Fleurier, Val-de-Travers Switzerland

[Author]

Posts