hello everyone,
first i want to congratulate David for the great job he made in FT and I wish him the best on his career…
I just want ask for help I already have the kk 2.1 hard case but I have no idea how to update it… I already read a lot of post but all of them are related with the no case one but anything about this one… could be a silly question but I really need your help… here all the pictures of the element I have…
1. homemade 6 pins cable and usbasp
2. this is the scheme I followed to connect the usbasp
3. orientation: How the pins are placed?????
4. kk2.1
5. always I get the same result….
I will really appreciated your priceless help….
i think you should try rewire:
programer MISO – MOSI KK
programer MOSI – MISO KK
and with that change it would not cause any damage to the board?????
well not sure.wiki says you have it right http://en.wikipedia.org/wiki/Serial_Peripheral_Interface_Bus
so i maybe mistaken it with something else
hahaha ok but I still need a help…. 🙁
i searched a littlebit and that first part of your orientation picture is correct pinout
and there is not a driver problem because I already flashed my turnigy9x with that and now I have it with open tx so I cannot find the problem….