[Egriesho]

Yes I did change the pitch to 180 when doing the initial setup. I have a feeling it’s in the PIDs since I’m using the suggested PID settings but not the RCExplorer electronics. I stated previously but I am running 30a hv speedix ESCs and Golden Power A2217-7 1250kv motors.

[Egriesho]

@DaveMak
I’m running speedix 30a hv escs with Golden Power A2217-7 1250KV Brushless Motors. And I’m using the stock PIDs that David provided on the product page. Would having the PIDs like this only effect the tail motor like what is happening in my case.

[Egriesho]

Dave, thanks for the suggestions. I have already balanced the props multiple times and have rotated the motors multiple times and neither have changed my results.

I am using motors and speed controllers that are based on the recommendations. They are neither the rcexplorer kit or the actual recommended ones, though they are high quality and should do the job. I am using the recommended PIDs that were described and shown how to put in in the setup video, this is my first frame where I have the capability to change PIDs so I am very very new to what they even do exactly.

I am using the triflight software. I have followed the cleanflight video, that David posted, to a T.

If a video would still be helpful just tell me and Ill see if I can get a quick clip of what its doing.

[Egriesho]

@Siclair, thank you for the suggestion. I watched the video and tried his different suggestions for if you are experianceimng problems and I’m still getting the same problem in BLHeliSuite. I will add a picture that shows the error I am get when trying to do the read setup function.

Attachments:

1. 

   BLE.png
   

[Egriesho]

@norwenkel How would I go about flashing the escs because I looked up the issue and a video came up saying use blheli suite. So I got the program and when I go to read the setup it says there’s an error and they can be read our something.

[Egriesho]

Well now I have turned of oneshot 125 which solved the problem of the motors ideling up but now when I go to do the throttle end point and esc calibration they all beep at dofferent times and I can’t get them synced up. And when i try to see if it worked all 3 motors throttle up but the when I go to give any directional control it screws with the output amount of the motors and takes them to 0(1000) and then back up to half of what they should be at.

[Author]

Posts